207SB .33 GL. SPEC. COATING HARDENE

The seller was fantastic. My original order was lost by FedEx, seller sent me out a replacement and maintained communication confirming I received my order. Product is also great! I used the 404 filler on an older wood boat I am restoring, did the job perfectly.

Is it possible to get this WITHOUT the can being beat to death? Every time I order something from them the cans are dented, bent and even punctured. What's the deal??

Sets up the 105 epoxy clear and hard without a blush, good for table tops or fixing boats.

Used in fiberglass over wood SUP board. Worked very well. Nice and clear and hard once set up.

Great product

I am impressed with it. I tried a few sample pieces of wood before using it on a real project so that I could get a good feel for working with it. This stuff is very clear and does not yellow in a short period of time. However, it is not UV resistant. Make sure you mix it with the 105 resin at an ambient air temperature of about 70+ degrees Fahrenheit to help prevent air bubbles from forming. It is OK if a few bubbles form since you can use a heat gun or torch to pull them out after you poor it on the surface. Heat gun is preferable. While it may be hard after 24 hours of applying it, it actually does not become fully hard until about 7 days later. It levels out very well. The final thickness ends up being about 1/16 to 3/32 of an inch. However, you can also spread it to a very thin layer with a squeegee if you want to use it as a base/sealer coat for finishing furniture. It fills in the wood grain pours nicely. I found it to work even better if you rub on a thin coat of polyurethane prior to applying the epoxy. This helps to prevent air bubbles from forming due to tiny air pockets in the wood. It does easily soak into end grain; so about two coats of polyurethane will be needed on the end grain to slow the absorption rate. The pumps they offer ( Mini Pump Kit for 301 and 305 in Quart, Gallon, 5 Gallon sizes ) are a great help to meter out the correct quantity of chemicals. However, the pumps do not necessarily work correctly at each pump action. Some of the pumping action will suck in air on the up stroke and prevent the pump from correctly metering the next output on the down stroke. Therefore, be attentive when using the pumps. The West System 207 hardener and 105 resin mix at a ratio of 3:1 For most projects, I used this kind of mixing cup ( 1/2 Pint Disposable Mixing Cups 100/Box ) since smaller cups can be too small, and I don't need large cups very often. This 207 hardener will not sick to these cups when fully hardened in them. Customer service at West System is excellent. I got a live person who referred me to a very knowledgeable representative in their office.

Works great

Got resin and hardener. Resin can was damaged. It was not damaged in shipping because box was fine and harder can was fine. Luckily had can on hand to pour into before started leaking. Don't understand why company would ship danaged can.

Shipped quickly. Can seemed only 3/4 full.